Dream Sock: Pairing and Unpairing Your Sensor

Unpairing your Sensor

To unpair your Sensor, follow the steps below:

  1. Unplug the Base Station and remove the Sensor.
  2. Press and hold the Base Station button while you plug the Base Station back in. Keep pressing the button until you hear the  Base Station chirp 4 times. The light ring will change to blinking orange. Release pressure after you hear a chirp.
  3. Quickly press the Base Station button twice (2x). The Base Station light ring is blinking orange, otherwise, the Sensor will not properly turn off.

If successful, the light on the bottom of the Base Station will not be illuminated, and the Sensor will NOT turn off. The Base Station will bounce white briefly before the blue disconnection notification sounds.

Pairing your Sensor

To pair your Sensor, follow the steps below:

  1. Place the Sensor on the Base Station charging port.
  2. The Base Station light will transition from bouncing white to solid white once the Sensor has paired.
  3. If there is a blue notification, the Sensor has not successfully paired. Follow the pairing instructions again. Please ensure the charging port is clean and the Sensor is making good contact with the charging port.

If successful, the “Sock” light on the bottom of the Base Station will be illuminated. When the paired Sensor is removed from the Base Station, the Base Station light bounces green.